TOHATSU 40 Service Manual page 121

Assembly
1 2
Apply genuine grease or equivalent friction surface
marine grease to bushings (11), spacer (12), throttle
shaft roller (13), and the grip portion of steering
handle (7) before assembly. DO NOT lubricate
friction piece (5).
1. Apply spray lubricant to the throttle cables. Work the cables back
and forth to ensure full coverage under the protective covering.
2. Assemble all components onto throttle shaft (4) and
1 2
connect throttle cables (3) to throttle shaft as required.
Route opposite end of throttle cables through steering handle (7).
3. Install throttle shaft in steering handle.
4. Install grip (2).
1 2
5. Fully assemble all remaining components as illustrated.
1 2
Installation
1. lnstall the tiller steering assembly onto steering
1 2
shaft (1). Torque handle B bolt to specification
(models 60, 70, 80, and 90).
3-/ 4-Cylinder
NOTE
MIDSECTION
5-7