TOHATSU 40 Service Manual page 214

Test 4 - Pulser Coil Test
Make sure all electrical terminals are connected
during this test except those that are noted in the
test procedure.
Check for continuity between chassis ground and
the ground connection for the magneto plate, CD
Unit, and ignition coils before conducting the
following procedure.
Reference the following electrical drawings for the
pulser coil test. The exciter and alternator coils have
been removed from both illustrations for clarity.
- Figure 2 - models 40 / 50 / 60B / 70B / 60C / 70C / 80 / 90.
13
- Figure 3 - models 115 / 120 / 140.
14
3-/ 4-Cylinder
NOTE
ELECTRICAL SYSTEM
T1481
7-35