SECTION 7
Special cases are the connectors used to test components
2
located on the coil plate assembly. For testing purposes, the
first connector is located at the far end of the cable (away from the
coil plate assembly) and usually found inside of the electrical box.
Bullet Connectors
Bullet connectors (1) are shown like this in electrical
3
drawings.
Disconnecting Bullet Connectors
1. Carefully examine the connector to determine which end is
removable and which end is fixed. Typically the insulation
surrounding the removable end is tapered so it fits inside of the
insulation for the fixed end.
2. Grasp the fixed end (1) of the connector and carefully pull
4
the removable end (2) straight out without twisting or
bending it.
Never twist or bend bullet connectors or damage to
the connectors will occur. Always PULL these
connectors apart.
7-8
NOTE
NOTE
T1479
T1477
T1465
3-/ 4-Cylinder