TOHATSU 40 Service Manual page 43

SECTION 2
6. Place the advancer arm in the minimum speed position
38
(throttle fully closed) and adjust stopper (6) to obtain the
specified ignition timing:
Model
115
120
140
The rubber damper must be installed on stopper when
39
making the adjustment.
7. Return advancer arm (3) to the maximum speed position
40
(wide open throttle) and verify that advancer arm contacts
the high speed stopper (5). If advancer arm does not contact
stopper, make fine adjustments using throttle link (2).
8. Adjust shift link rod to specification.
41
Model
115
120
140
2-34
Ignition Timing - Throttle Closed
ATDC 10˚ ± 1˚
ATDC 10˚ ± 1˚
ATDC 10˚ ± 1˚
NOTE
Length
Shift Link Rod
3.66 in [93 mm]
3.66 in [93 mm]
3.66 in [93 mm]
T1757
T1085
T1086
T1087
3-/ 4-Cylinder