General Precautions - TOHATSU 40 Service Manual

SECTION 5

GENERAL PRECAUTIONS

Before performing any service work on the midsection, read and
understand the Service Safety section at the beginning of this
manual.
Replace locking fasteners when their locking feature becomes
weak. Use only factory replacement parts.
When using compressed air to clean ordry parts, make sure air
supply is regulated not to exceed 25 psi [172 kPa / 1.76 kg/cm ].
2
Always inspect and test the start-in-gear prevention system before
returning engine to customer.
Most service work on the midsection requires preliminary steps to
remove major components. Follow all applicable procedures in
other sections when indicated.
Use threadlockers and follow torque specifications as indicated to
ensure shock-absorbing components remain secure after returning
the engine to service.
5-2
3-/ 4-Cylinder