TOHATSU 40 Service Manual page 175

SECTION 6
Propeller Shaft Housing Needle Bearing -
Models 60B and 70B
21 22
Obtain needle roller bearing puller kit. Reference the
following specification table for propeller shaft
housing needle bearing Removal and Installation
special tool requirements :
Tool
Shaft, Needle Bearing Puller
Retainer, Needle Bearing Puller
Guide, Needle Bearing Puller
Plate, Needle Bearing Puller
Washer, 13-21-2.5
Nut, 12P1.5
Stopper, Needle Bearing Puller
Removal
21
1. Remove oil seal from propeller shaft housing.
2. Remove roller bearing from propeller shaft housing by heating
the housing with a heat gun.
3. Place shaft (1) through needle bearing.
4. Attach retainer (2) to shaft groove (G) with raised surface of
retainer facing bearing.
5. Slide guide (4) and plate (5) onto shaft and secure with washer
(6) and nut (7).
6. Tighten nut (7) until needle bearing releases from housing.
6-38
NOTE
Part Number
1 3B7-72702-0
2
353-72703-0
4
353-72705-0
5
353-72701 -0
6
346-72707-0
7
3B7-72735-0
8
353-72704-0
Model
60B / 70B
60B / 70B
60B / 70B
60B / 70B
60B / 70B
60B / 70B
60B / 70B
T1442
3-/ 4-Cylinder