TOHATSU 40 Service Manual page 213

SECTION 7
6. Attach lanyard to emergency stop switch.
7. Crank engine.
8. At cranking RPM, the tester should show the following results:
Engine Models
40 / 50 / 60 / 70 / 80 /
90 / 115 / 120 / 140
9. If the exciter coil test results are not within the acceptable range,
replace the exciter coil set. See Ignition System Repair Procedures-
Exciter Coil.
10. Reconnect all wires disconnected during test.
11. Return to flow chart.
7-34
Test Results
130 DVA Minimum
Test 1 - 10 - 15 DVA
Test 2 - 100 - 200 DVA
T1480
3-/ 4-Cylinder