SECTION 7
Alternator coil (1) terminals. Note that these terminals
21
interconnect cable from coil plate assembly (2) to rectifier /
regulator (3):
Engine Models
40 / 50 / 60B / 70B /
60C / 70C / 80 / 90
3. Remove the screws (1) and remove coil plate assembly
22
(2) from the mounting bracket.
Cleaning and Inspection
Clean upper main bearing seal (1), guide plate (2) and
23
ignition timing link (3) with isopropyl alcohol as required.
Check for the following and repair or replace as required:
• Bent, chipped, cracked, or corroded guide plate.
• Broken or bent ignition timing link.
7-70
Disconnect Terminals
4
5
6
7
T1503
T1504
T1505
3-/ 4-Cylinder