TOHATSU 40 Service Manual page 244

Installation
Install in reverse order of removal.
Disconnect negative battery cable from battery
before installing exciter coil.
Use threadlocker on screw threads before installing
screws.
Use a length of shrink tube to fabricate a new coil
plate assembly cable shield as required. Inside
diameter of shrink tubing must be large enough to
pass over the largest connector.
Pulser Coil Assembly
On models 115 / 120 / 140 you must replace the pulser
coil assembly. Individual pulser coils are not available.
On models 40 / 50 / 60B / 70B / 60C / 70C / 80 / 90
you must replace the entire coil plate assembly (see
procedure later in this section). Individual pulser coils
are not available.
Disconnect negative battery cable from battery
before removing pulser coil assembly
Removal (models 115 / 120 / 140)
1. Remove the flywheel.
2. Disconnect the following pulser coil (1) terminals. Note
15
that these terminals interconnect cable from coil plate
assembly (2) to cable from CD Unit (3):
• Pulser coil terminals (4), (5), (6), (7), (8), (9), (10), (11), (12), and (13).
3-/ 4-Cylinder
NOTE
NOTE
ELECTRICAL SYSTEM
T1482
7-65