3. Adjust the throttle cable length at adjusting
4
5
6
nut (14) so grip (2) contacts stop screw (15)
when the grip is in the fully open position (models 60, 70, 80 and
90). Return grip to fully closed position and confirm sufficient
freeplay between grip and stop screw.
4. Adjust throttle friction piece (5) by tightening or loosening
6
the bolt to obtain proper grip turning resistance.
LOWER ENGINE COVER
Removal
1. Remove powerhead as described in Section 4.
2. Remove control cables and electrical leads as required from lower
engine cover.
3. Remove nut or clip from shift lever shaft (1). Disconnect
1
shift rod (2) from shift rod lever (3).
4. Remove lower engine cover bolts (4).
2
5. Lift cover off engine base.
3
3-/ 4-Cylinder
MIDSECTION
T1261
T1262
T1263
T1264
T1265
5-9