TOHATSU 40 Service Manual page 216

2. Setthe digital multimeter to ohms and connect the
14 15
leads to (one terminal at a time) to test the resistance
of each pulser coil:
Engine Models
40 / 50 / 60B / 70B /
60C / 70C / 80 / 90
115 / 120 / 140
3. The meter should indicate the following resistance for each
pulser coil:
Engine Models
40 / 50 / 60 / 70 / 80 / 90
115 / 120 / 140
4. If the resistance is not within the indicated range, replace the
pulser coil set. See Ignition System Repair Procedures - Pulser
Coil. After repairs are made, return to Ignition System Performance
Testing Flow Chart.
If the resistance is within the indicated range, proceed to the next
step.
3-/ 4-Cylinder
ELECTRICAL SYSTEM
Connect Multimeter
Between These Terminals
• 4 and 6
• 4 and 8
• 4 and 10
• 4 and 6
• 4 and 8
• 4 and 10
• 4 and 12
Results
160 - 220 Ω ± 25%
187 - 253 Ω ± 25%
T1481
7-37