TOHATSU 40 Service Manual page 25

SECTION 2
Item
Electrical • Check for loose connections.
Wiring • Inspect wires and insulation for
damage.
Ignition • Check and adjust timing.
Timing and • Adjust linkage.
Carburetor
Adjustments
Throttle and Inspect for the following:
Choke • Loose ball joints and lock nuts
Valve • Bent link rods
Linkage • Loose rod snaps
Lubrication Clean and inspect the following:
System • Oil tank
• Oil hoses
• Oil filter
• Check components for damage and
leakage
Sacrificial • Inspect amount of erosion.
Anodes • Test for proper installation.
Water Intake • Check for blockages.
Screens
2-16
Inspection
• •
• •
• •
• •
•
•
Remarks
See
Synchronization and
Linkage Adjustments
in this section.
Replace automixing
check valve and oil
hoses every 2 years.
Replace when anode
has been reduced to
2/3 its original size
(1/3 eroded).
See Anodes -
Inspection and Testing
in this section.
Remove and clean as
required.
3-/ 4-Cylinder