3. For models 40 / 50 / 60 / 70 / 80 / 90 ONLY: Remove coil
7
plate assembly cable clamp screws (1) and cable clamp (2).
4. For models 40 / 50 / 60 / 70 / 80 / 90 ONLY: Carefully slit
8
coil plate assembly cable shield (1).
Make sure you don't cut electrical conductors inside
of coil plate assembly cable when you slit cable
shield.
On models 60B / 708 / 60C / 70C there are two coil
plate assembly cables (1) and (2). Make sure you slit
the cable shield for coil plate assembly cable that
contains the electrical conductors for the exciter
coil(s).
5. For models 40 / 50 / 60 / 70 / 80 / 90 ONLY: Cut tie wrap.
6. For models 40 / 50 / 80 / 90 ONLY: Remove exciter coil
9
screws (1) and exciter coil from the mounting bracket.
On models 60B / 70B remove both exciter coils, they
are replaced as a pair.
3-/ 4-Cylinder
NOTE
NOTE
ELECTRICAL SYSTEM
T1492
T1493
T1495
7-63