TOHATSU 40 Service Manual page 41

SECTION 2
5. Place the advancer arm in the minimum speed position
30
(throttle fully closed) and adjust stopper (6) (Pre-setting
length = 12 mm) to obtain the specified ignition timing:
Model
80A
90A
The rubber damper must be installed on stopper
when making the adjustment.
6. Return advancer arm (3) to the maximum speed position
31
(wide open throttle) and check if comes in contact with the
high speed stopper (5). If advancer arm does not contact stopper,
make fine adjustment using throttle link (2).
7. Adjust shift link rod to specification.
32
Model
80A
90A
2-32
Ignition Timing - Throttle Closed
ATDC 5° ± 1˚
ATDC 5° ± 1˚
NOTE
Length
Shift Link Rod
3.11 in [79 mm]
3.11 in [79 mm]
T1085
T1086
T1087
3-/ 4-Cylinder