TOHATSU 40 Service Manual page 134

SECTION 5
2. Pull lower mount bracket (2) off steering shaft.
7
3. Lift steering shaft from swivel bracket.
8
4. Remove the bracket bolt nut.
9
5. Remove the bracket bolt, upper cylinder pin (3) if
10
equipped, and lift swivel bracket (4) from stern brackets.
6. Remove the gas assist cylinder or power trim/tilt unit if equipped.
Refer to Section 8 for power trim/tilt removal.
7. Remove the stern brackets from engine stand.
8. If required, fully disassemble and inspect the manual tilt or gas
assist tilt components as illustrated. Refer to Section 8 for servicing
power trim/tilt.
Models 40 and 50 - Manual Tilt
11
Models 40 and 50 - Gas Assist Tilt
12
Models 60 and 70 - Manual Tilt
13
Models 60 / 70 / 80 / 90 - Gas Assist Tilt
14
5-20
T1305
T1301
T1302
T1303
T1304
3-/ 4-Cylinder