TOHATSU 40 Service Manual page 245

SECTION 7
3. Remove the screws (1) and clamps (2) and remove pulser
16
coil assembly (3) from the mounting bracket (4).
Cleaning and Inspection
Clean upper main bearing seal and o-ring (1) guide plate
17
and bushing, ignition timing link, alternator assembly,
electrical leads and connectors with isopropyl alcohol as required.
Check for the following and repair or replace as required:
• Bent, chipped, cracked, or corroded guide plate and bushing.
• Electrical leads and connectors for integrity, cut or cracked
insulation.
• Broken or bent alternator assembly and missing screws.
Apply light coat of low temperature lithium grease to guide
17
plate and bushing (2).
7-66
T1501 T1502
3-/ 4-Cylinder