TOHATSU 40 Service Manual page 314

Removal
1. Operatethe PT/T motor and raise engine to fully UP position.
Engage the tilt stopper to lock engine in position.
If power trim/tilt motor is not functional, open manual
valve several turns and raise engine by hand.
2. Remove thrust rod (1) if equipped, and upper
4 5
cylinder pin (2).
3. With tilt stopper engaged, fully retract the piston rod(s) and
disconnect the battery.
4. Disconnect two PT/T motor leads (3) from the UP and
6
DOWN solenoid switches in the electrical box and remove
them from the lower motor cover and stern bracket.
The PT/T motor cable on old style PT/T units
contains an additional ground lead which must be
disconnected. For ease of identification and to
prevent improper wire connections during testing
and installation, mark all electrical leads before
disconnecting.
5. Remove the PT/T assembly mounting bolts (old style PT/T)
7
and lower cylinder pin (4).
6. Lift the PT/T unit from between the stern brackets.
8
3-/ 4-Cylinder
T1325
NOTE
NOTE
POWER TRIM/TILT
T1326 T1327
T1328
T1329
8-15