TOHATSU 40 Service Manual page 299

SECTION 7
Cleaning and Inspection
Clean coil plate assembly, upper main bearing seal (1), set
17
ring, ignition timing link, exciter coil(s), pulser coils, coil
leads, and coil connectors with isopropyl alcohol as required.
Check for the following and repair or replace as required:
• Bent, chipped, cracked, or corroded coil plate assembly.
• Coil leads for integrity, cut or cracked insulation, and damaged
connectors.
• Broken or bent exciter coil laminations, damaged exciter coil
windings, and missing exciter coil screws.
• Broken, cracked, or misaligned pulser coils and missing pulser
coil screws.
• Free motion of ignition timing link (1). Repair, adjust, and
18
lubricate as needed, see Section 2.
Installation
Install in reverse order of removal.
Use threadlocker on screw threads before installing
screws.
7-120
NOTE
T1498
T1499
3-/ 4-Cylinder