TOHATSU 40 Service Manual page 126

SECTION 5
Cleaning and Inspection
All worn, damaged, or missing parts must be replaced.
1. Before cleaning, examine the following rubber parts as
12
applicable and remove if damaged, dry, or brittle:
• Exhaust housing grommet (1).
• Idle port grommet (2).
• Lower engine coverseal (3).
• Engine base drain plugs (4).
• Water pipe seal (5) and locking rubber (6).
Use super bond adhesive to install new rubber parts as needed on
metal surfaces. Make sure metal surfaces are clean and dry before
installation of rubber parts.
5-12
T1276
3-/ 4-Cylinder