TOHATSU 40 Service Manual page 169

SECTION 6
Removal
1. Insert shaft (1) through needle bearing from water pump
2
side of gearcase.
2. Attach retainer (2) from propeller shaft side of gearcase to
2
specified shaft groove. Make sure retainer is fully seated in
groove with raised surface facing bearing:
Models 40 and 50 - groove (3).
3
Models 60B / 60C / 70B / 70C / 80 / 90 - groove (4).
4
3. Slide guide (5) onto shaft from water pump side of gearcase.
2
Make sure guide is seated in bearing.
4. Install plate/flange (6), washer (7), and nut (8) onto shaft.
5. Hold end of threaded shaft with wrench and tighten nut (8) until
bearing releases from housing.
6-32
T1425
T1426
T1427
3-/ 4-Cylinder