2. Install o-ring (9) on press B (8). Place washer (3) on bolt
12
(10) and insert bolt through hole closest to shoulder (12).
3. Attach press B (8) to pressing rod (6) by tightening bolt
13
(10) into threaded portion of rod.
4. Install bearing outer pressing guide (7) on gearcase so F
14
mark (11) faces cam rod port (13). Holes in guide (7) should
align with water pump bolt holes in gearcase.
5. Assemble bolts (2), washers (3), flywheel puller plate (4),
15
and pressing collars (5). F-marks (11) must be aligned.
3-/ 4-Cylinder
T1433
T1434
GEARCASE
T1436
T1435
6-35