Open shut-off cock at the pressure
–
measuring device -V.A.G 1318- (lever in
direction of flow of fuel).
–
Start engine and run in idle.
After the pressure has been built up,
–
switch ignition off. At the same time the
return-flow hose (with blue marking)
must be pressed together.
If the pressure does not drop:
– Replace the fuel pressure regulator.
If the pressure again drops:
Check line connections, "O" -rings on fuel
–
rail and injectors for leaks.
Inspect pressure measuring device for
–
leaks.
Note
Before removing the pressure gauge
appliance, reduce the fuel by opening the
shutoff cock and place a cleaning cloth
around the connection point.
Testing injection valves
Special tools and workshop equipment required
t
Handheld multimeter, e.g. -V.A.G 1526 A -
t
Voltage tester, e.g. - V.A.G 1527-
t
Measuring tool set -V.A.G 1594 A -
t
Test box -V.A.G 1598/22-
t
Current flow diagram
A - Testing resistances of the injection valves
–
Remove fuel distributor
–
Disconnect plug at the injection valve to be tested.
→
Chapter.
200