Remove crankshaft timing belt sprocket.
–
Lock toothed belt gear - crankshaft with
counterholder -MP 1-310- or
counterholder -T30004 -.
Note
When screwing on the counterholder place
2 washers between the timing belt gear
and the counterholder.
–
Drain engine oil.
–
Removing the oil pan
–
Unscrew front sealing flange.
Remove sealing flange, if necessary
–
release by applying slight blows with a
rubber-headed hammer.
Use a flat scraper to remove sealant
–
residues on the cylinder block.
Use a rotating plastic brush to remove
–
sealant residues on the sealing flange
(wear protective goggles).
Clean sealing surfaces, they must be free
–
of oil and grease.
Install
Note
The sealing flange must be installed within
5 minutes after applying the silicone
sealant.
→
Chapter.
47