Fitting location: stops for gasket ring at the
bottom part of the intake manifold -arrows-
If no stops are present at the bottom part
of the intake manifold, stick the gasket ring
with glue -D 000 801- and hardener - D 000
802- to the bottom part of the intake
manifold.
Disassembling and assembling top part of intake manifold
1 -
8 Nm
2 - Throttle valve control unit -J338-
–
check
→ Chapter
adapt this for a replacement engine
–
control unit
→ Chapter
3 -
Gasket ring
–
replace if damaged
4 -
Gas pressure valve
5 -
Threaded insert, 8 Nm
6 -
Top part of intake manifold
7 -
Vacuum setting element
Testing intake manifold changeover
–
→ Chapter
Variable intake manifold changeover
8 -
valve -N156-
*/**
Testing intake manifold changeover
–
→ Chapter
9 -
Earth strap
10 -
11 -
10 Nm
Cap
*
192