Oil the thread head of the gasket ring
–
extractor -MP 1-226-, position and forcely
screw into the gasket ring as far as
possible.
Slacken knurled bolt and turn inner part
–
against the crankshaft until the gasket
ring is pulled out.
Install elastomer gasket ring.
Lightly oil the sealing lip of the gasket
–
ring.
Fit insertion sleeve from -MP 1-314- on
–
the crankshaft stub.
Slide gasket ring over the insertion
–
sleeve.
Press in the gasket flush using the central
–
screw -1- and press in the insertion
sleeve from -MP 1-315-.
Install PTFE gasket ring.
Note
The sealing lips of the gasket ring must be
neither oiled nor greased.
Remove oil residue on the crankshaft
–
stub with a clean cloth.
42