Engine Lubrication; Removing And Installing Parts Of The Lubrication System - Skoda OCTAVIA MK1 Service Manual

Engine lubrication

Removing and installing parts of the lubrication system

Note
If considerable quantities of metal swarf
or abrasion is found in the engine oil
when carrying out engine repairs,
t
carefully clean the oil galleries in order to
avoid consequential damage and
additionally replace the oil cooler.
The engine oil level must never exceed
t the max. marking - risk of damage to
catalytic converter!
Check the engine oil, amount of oil, oil
specification: → Octavia
1 - Oil pump
Duocentric pump with pressure relief
–
valve 1.2 MPa (12 bar)
Before installing, check whether both
–
dowel sleeves for centering oil
pump/cylinder block are present
if there is any scoring on contact
–
surfaces and gears, replace
Torque of oil pump cover at oil pump
–
housing: 10 Nm
2 - Oil pump sprocket
– Check fitting position
Fits onto oil pump shaft in one position
–
only
3 - 20 Nm
4 - Oil pump chain
5 - Sealing flange
coat with silicone sealant -D 176 404 A2-
–
→ Chapter
replace the gasket ring for the crankshaft
–
→ Chapter
6 - 15 Nm
85