Inspecting Semi-Automatic Tensioning Pulley - Skoda OCTAVIA MK1 Service Manual

Tighten the timing belt. Turn with
–
-T10020- at centering piece to the left (in
direction of arrow) up to the stop.
Slacken the timing belt until the notch -1-
– and the pointer -2- are positioned
opposite.
Tighten clamping sleeve securing semi-
–
automatic tensioning pulley to 25 Nm.
Turn the crankshaft fully twice and check
–
the setting.
– Install bottom timing belt guard.
Install vibration damper (pay attention to
– fitting position: hole of the vibration
damper is above the lobe on the timing
belt sprocket).
Note
Before installing engine support, insert
bolts into engine support.
– Install engine support
– Install engine mount
– Remove supporting device.
– Install middle and top timing belt guard.
Install tensioning device for V-ribbed
–
belt. Tightening torque:
– Install the V-ribbed belt

Inspecting semi-automatic tensioning pulley

Test condition
l Toothed belt fitted on and tensioned.
→ Anchor.
→ Chapter.
→ Anchor.
34