Skoda OCTAVIA MK1 Service Manual page 44

Put the counterholder -MP 1-221- into the bore
– hole on the cylinder block and screw onto the
pressure plate.
– Release screws for pressure plate.
Note
Replace screws for pressure plate.
Tighten bolts to 60 Nm and torque a further
–
1
90° / turn.
4
Removing and installing drive plate
Special tools and workshop equipment required
t Torque wrench 5 to 50 Nm (e.g. -V.A.G 1331 -)
t Torque wrench 40 to 200 Nm (e.g. -V.A.G 1332 -)
t Counterholder for clutch -MP 1-221-
t Depth gauge
Removing
Attach counterholder -MP 1-221- with
– M8x45 bolt to the drive plate. Place two
M10 nuts between the counterholder and
the driver disc -1-.
– Release screws for driver disc.
Install
Remove the intermediate plate
–
→ Anchor.
44