Install noise insulation; -arrows- in the
–
lower part of the figure.
–
Remove V-ribbed belt
Remove ribbed V-belt tensioning device
–
→
Chapter.
Remove top and middle toothed belt
–
guard
→
Chapter.
Position crankshaft on TDC cylinder 1
–
→
Chapter.
Take toothed belt off camshaft sprocket
–
→
Chapter.
Note
The vibration damper and the bottom
t
toothed belt guard can remain installed.
The timing belt remains fitted onto the
t
timing belt crankshaft sprocket.
Pay attention to instructions for the
t
removal and installation of the timing
belt
→
Chapter.
Release screws -1- and -5- and remove
–
timing belt guard at rear -2-.
Unscrew coolant pump -4- and carefully
–
guide out along the engine support.
Install
Clean sealing surface for "O"-ring or
–
smoothen.
– Moisten new "O"-ring -3- with coolant
→
Chapter.
102