– Unlatch and disconnect lines -3- and -4-.
Raise catches -1- and -2- with a
–
screwdriver and remove the fuel gauge
sender towards the bottom -arrow-.
Install
Insert the fuel gauge sender in the fuel
–
delivery unit guides and press upwards
until they latch into position.
Removing and installing the fuel tank
Observe safety measures
Observe rules for cleanliness
Special tools and workshop equipment required
t
Engine/gearbox jack (e.g. -V.A.G 1383 A -)
t
Fuel extraction device (e.g. -V.A.G 1433 A-)
Removing
On models fitted with a coded radio set, pay attention to the coding; determine if
–
necessary.
–
Disconnect the earth strap from the battery with the ignition off.
–
Empty fuel tank with fuel extraction equipment (e. g. -V.A.G 1433 A -).
Remove rear axle:
–
installing the rear axle
–
Unscrew cover (below rear seat).
–
Unlock and unplug 4-pin connector of flange at fuel tank.
– Open the fuel tank cap, lever out tensioning ring in rubber bowl (around filler neck).
–
Press through rubber bowl to the inside.
–
Remove rear right wheelhouse liner.
–
Unscrew fuel filler neck below wheelhouse liner.
→
Chapter.
→
Chapter.
→ Running gear, Rep. Gr. 42; Repairing rear axle; Removing and
112