Release on left and right each one screw
–
-arrow- of the rear intake manifold
suspension.
Press off upper part of collecting intake
–
manifold to the rear from lower part of
collecting intake manifold.
Note
Seal the intake passages in the bottom
part of the collecting intake manifold with
plug (clean cloth).
Install
Note
Replace seals if damaged.
Insert upper part of collecting intake
–
manifold onto the bottom part.
– Allow to clip left and right retaining eyes.
Coat screws of rear intake manifold
–
suspension at collar with commercially
available lubricant and tighten to 10 Nm.
Adjusting throttle control cable
–
→
Chapter.
If necessary, top up with coolant
–
→
Chapter.
Interrogate fault memory, perform basic
setting:
→ 1.6 ltr./74 kW engine, Simos 2
–
Injection and ignition system; Rep. Gr. 01;
Self-diagnosis; Interrogate and erase fault
memory, Basic setting of engine
removing and installing cylinder head cover
Special tools and workshop equipment required
t
Torque wrench 5 to 50 Nm (e.g. -V.A.G 1331-)
Removing
–
Remove upper part of collecting intake manifold
–
Remove top toothed belt guard.
–
Unscrew nuts for cylinder head cover.
→
Chapter.
60