Removing And Installing Crankshaft - Skoda OCTAVIA MK1 Service Manual

Removing and installing crankshaft

Note
Repairs to the clutch:
t gearbox 02K; Rep. Gr. 30; Repairing the
clutch.
The engine should be attached to the
engine repair stand with engine holder
t
-MP 1-202- for carrying out removal and
installation work.
1 - 15 Nm
2 - Gasket ring
– replace → Chapter
– pay attention to different version
3 - Front sealing flange
– removing and installing
4 - Thrust washers
– pay attention to different version
in bearing 3, for cylinder block or
–
bearing cap
– lubricating grooves point outwards
5 - Bearing shell
Identification for ordering replacement
–
parts → Fig.
– for cylinder block with lubricating groove
do not mix up used bearing shells
–
(mark)
6 - Sprocket
– for oil pump drive
7 - Crankshaft
– Axial play when new: 0.07...0.21 mm
– Wear limit: 0.30 mm
– Crankshaft bearing journal: Ø 54.00 mm
– Conrod bearing journal Ø 47.80 mm
→ 5 speed Manual
→ Fig.
→ Chapter
36