Engine Cooling; Removing And Installing Parts Of The Cooling System; Parts Of The Cooling System; Draining And Filling Up Coolant - Skoda OCTAVIA MK1 Service Manual

Engine cooling

Removing and installing parts of the cooling system

Parts of the Cooling System

Note
When the engine is warm the cooling
t system is under pressure. Reduce
pressure before repairs.
The hose connections are secured with
t spring-type clips. In the event of repairs
only use spring-type clips.
Use pliers for spring strap clips to fit the
t
spring strap clips.
t Always replace seals and gasket rings.
When installing fit the coolant hoses free
of stress, without them touching any
t other components (pay attention to the
marking on the coolant connection and
hose).

Draining and filling up coolant

t
→ Chapter.
t Coolant mixing ratios
Checking the coolant system for
t
tightness.
1 - Radiator
after replacing fill entire system with
–
fresh coolant
2 - Oil cooler
– removing and installing
3 - Coolant pump, coolant regulator
Removing and installing coolant pump
–
→ Chapter
– check smooth operation
Removing and installing coolant
–
regulator → Chapter
– test, data → Chapter
4 - Cylinder block
→ Anchor.
→ Chapter
94