Skoda OCTAVIA MK1 Service Manual page 177

valve control unit:
000 xxxx
0
000 not assigned
0
1 during the adaptation of the throttle valve control unit, a fault has occured
(interrogate fault memory
1 Throttle valve control unit dead (clock ratio = 0)
1 Adaptation aborded due to a too low battery voltage (below 8 V)
1Idling switch separated (interrogate switch)
Display group 022 (position of camshaft to crankshaft):
l Engine runs in idling speed
Reading measured
value block 22
xxx xxx mg/s xx x
rpm
1 2
drawn in air mass
Idling speed
Note
t Regarding display fields 3 and 4:
t The speed sender at the crankshaft is a speed and reference marking sender (gaps). The
Meaning, if display positions = 1
Adaptation status of the throttle valve control unit
→
→ ← Readout on display
x
3 4 ← Display fields
Number of teeth of the rotor at the crankshaft
when changing the hall sender signal from + to -
Number of teeth of the rotor at the crankshaft when
changing the hall sender signal from - to +
Chapter)
177
Specificati Analysis
on
86...90 → Ancho
r
26...30 → Ancho
r
76...164 → Chapt
mg/s er
- → Chapt
er