Replacing valve stem seals
l
Cylinder head fitted
Special tools and workshop equipment required
t
Extractor -MP 1-206-
t
Pressure hose -MP 1-210-
t
Valve lever -MP 1-211-
t
Insertion tool -MP 1-212-
t
Assembly device for valves -MP 1-213-
Removing
–
Remove the camshaft
Remove bucket tappets (do not interchange) and lay aside with the contact surface facing
–
down.
–
Unscrew the spark plugs.
–
Position piston of the relevant cylinder in bottom dead centre.
Insert the assembly device -MP 1-213-
–
and adjust bearing to the stay bolt
height.
Screw the pressure hose -MP 1-210- into
–
the spark plug thread and apply constant
pressure of at least 0.6 MPa (6 bar) in the
cylinder.
Remove valve springs with valve lever
–
-MP 1-211 -.
Note
If valve collets are tight, slacken with slight
blows of a hammer on the valve lever.
→
Chapter.
78