-holes offset-.
Replacing gasket ring for crankshaft -on the belt pulley side-
Special tools and workshop equipment required
t
Torque wrench
t
Counterholder -T30004- or Counterholer -MP 1-310 -
t
Gasket ring extractor -MP 1-226-
t
Insertion sleeve -MP 1-314-
t
Insertion sleeve -MP 1-315-
t
Guide bushing -T10053/1-
t
Pressure bushing -T10053-
Removing
–
Remove V-ribbed belt
–
Removing timing belt
Remove crankshaft timing belt sprocket.
–
Lock toothed belt gear - crankshaft with
counterholder -T30004- or counterholder
-MP 1-310 -.
When screwing on the counterholder
–
place 2 washers between the timing belt
gear and the counterholder.
Screw central screw of timing belt again
–
into the crankshaft.
Unscrew inner part of the gasket ring
–
extractor -MP 1-226- two turns (approx. 3
mm) out of the outer part and lock with
knurled screw.
→
Chapter.
→
Chapter.
41