measured value block" and further select
display group 098.
Check the operating state of the throttle valve control
unit in display field 3.
Specified value: 00000000
Meaning of the digits in the 8-digit numerical block for
the operating condition of the throttle valve control
unit:
000
xxxx
0
000
not assigned
0
1
During the adaptation of the throttle valve control unit, a fault has occured
(interrogate fault memory
1
Throttle valve control unit dead (clock ratio = 0)
1 Adaptation aborded due to a too low battery voltage (below 8 V)
1Idling switch separated (interrogate switch)
If the specified values are not reached:
–
Adapt the engine control unit to the throttle valve control unit
–
Repeat check.
If the nominal values are again not reached:
Test voltage supply of throttle valve control unit and cables to engine control unit
–
→
Anchor.
Check throttle valve potentiometer
Test condition
l
Coolant temperature at least 80 °C
Test sequence
Connect vehicle system tester -V.A.G 1552- and select address word 01 "Engine
–
electronics". Ignition switched on.
Select 08 for the function "read measured value block" and further select display group
–
001.
In display field 2 check whether the coolant
temperature is above 80 °C.
– Switch over in display group 3 as follows:
Meaning, if display positions = 1
→
Chapter)
Reading measured value block 1
->
0/rpm
237
Reading measured value block 98
->
4.20 V
3.48 V
00
→
Chapter.
90°C 0.80 V
00000000
00000000