Fitting position of the semi-automatic
tensioning pulley
The angle bracket -arrow- must engage in
the recess at the cylinder head.
Special tools and workshop equipment
required
t
Torque wrench
t
Counterholder -MP 1-216-
t
Two-hole nut turner -T10020-
t
Counterholder -MP 1-310-
t
Supporting device - MP 9-200-
Removing toothed belt
Engine installed
–
Remove V-ribbed belt
– Remove ribbed V-belt tensioning device.
Rotate crankshaft to TDC of cylinder 1
–
-arrow- (vehicles with manual gearbox).
TDC marking on flywheel and reference
mark must be aligned.
→
Chapter.
30