Skoda OCTAVIA MK1 Service Manual page 19

– Insert intermediate plate on sealing flange and push onto the dowel sleeves -arrows-.
Vehicles fitted with a manual gearbox
– Lubricate the drive shaft serration lightly with grease -G 000 100 -.
– If necessary check the centering of the clutch disc.
Install slave cylinder:
–
control.
Installing shift mechanism:
–
gearshift mechanism.
Setting the shift mechanism:
–
gearshift mechanism.
Vehicles with automatic gearbox
Only use nuts which are approved in the parts list, for attaching torque converter to the
–
driver disc.
Vehicles with air conditioning
Install AC compressor:
–
and installing compressor from holder.
All vehicles
Install the vane pump for the power-assisted steering:
–
Removing and installing the vane pump for power-assisted steering.
Install drive shafts:
–
Removing and installing the drive shaft.
Install the front exhaust pipe and the exhaust system so that they are not under tension
–
→ Chapter.
– Align unit mounting
– Install the V-ribbed belt
– Install coolant hose
– Filling system with coolant
The drained off coolant must only be then re-used if the cylinder head, cylinder block,
–
radiator or heat exchanger were not replaced.
Place connecting harness for engine into cable duct and connect the 10-pin plug
–
connection.
– Connect the 28-pin connector at engine control unit -J361-.
– Fit cooling water tank cover.
– Install windscreen wiper arms
→ 5 speed Manual gearbox 02K; Rep. Gr. 30; Repairing the clutch
→ 5 speed Manual gearbox 02K; Rep. Gr. 34; Repairing the
→ 5 speed Manual gearbox 02K; Rep. Gr. 34; Setting the
→ Heating, Air conditioning, Rep. Gr. 87; Air conditioning; Removing
→ Running gear, Rep. Gr. 40; Repairing front wheel suspension;
→ Chapter.
→ Chapter.
→ Chapter.
→ Chapter.
→ Body Work; Rep.-Gr. 66; Trim panels
→ Electrical System Rep.- Gr. 92; windscreen wiper and
→ Running gear, Rep. Gr. 48;
19