Skoda OCTAVIA MK1 Service Manual page 241

– Enter function 04 "Initiate basic setting" and further select display group 098.
The following appears in the display:
After the Q key has been pressed, the throttle valve positioner
moves from the min. limit (throttle valve is closed) up to the max.
limit (throttle valve is opened).
The control unit stores the corresponding voltage value in the
permanent memory.
This procedure takes up to 10 seconds. Afterwards, the throttle
valve positioner remains free of stress.
The following appears in the display:
The adaptation of the engine control unit to the throttle
valve control unit was performed successfully.
Note
If one of the following displays is shown, a successful
adaptation could not be performed.
The following appears in the display:
Note
Meaning of the digits in the display field
3:
Display field 3 Meaning of the display
XXXX1XXX a fault is entered in the fault memory; interrogate fault memory
XXXXX1XX Throttle valve control unit dead (clock ratio = 0)
XXXXXX1X Adaptation aborded due to a too low battery voltage (below 8 V)
XXXXXXX1 Idling switch separated (interrogate switch), check
Meaning of the digits in the display field 4:
Display field 4 Meaning of the display
1X a fault is entered in the fault memory; interrogate fault memory
X1 Perform adaptation of the throttle valve control unit
Note
System in basic setting
4.20 V 3.48 V
241
System in basic setting
98 ->
4.20 V
00000000
System in basic setting
->
4.20 V 3.48 V
00000100 00
98
00001100
→ Chapter
→ Chapter or → Chapter
→ Chapter
3.48 V
01
98
->
10