Only insert the drive
–
plate using the
washer with recesses
-1-.
Insert bolts -3- and
–
tighten to 30 Nm.
Inspect installed dimension of drive plate
–
at the 3 mounting holes for the torque
converter and calculate mean value.
t Nominal value -a- 19.5...21.1 mm
Note
The measurement is made through the 3
outer holes of the drive plate to the milled
surface of the cylinder block.
If the specified value is reached:
–
Installing the drive plate.
–
Installing intermediate plate.
Attach drive plate with washer and new
–
screws, torque 60 Nm +
If the measurement is less than the
specification:
–
Remove the driver plate.
–
Installing intermediate plate.
1
/
turn (90°).
4
45