Install -T10053/1- guide bushing on the
–
crankshaft stub.
Slide gasket ring over the guide bushing
–
onto the crankshaft stub.
Press in gasket ring with pressure
–
bushing -T10053- up to the stop. Use the
old central screw for the crankshaft
timing belt sprocket for this purpose.
Proceed as follows for both versions
Install timing belt gear onto the
–
crankshaft and lock with counterholder -
MP 1-310-.
Note
Replace central screw for toothed belt
gear.
Tighten central screw to 90 Nm and
–
torque a further
– Installing the timing belt
– Install the V-ribbed belt
Removing and installing pressure plate
Special tools and workshop equipment required
t
Torque wrench 40 to 200 Nm (e.g. -V.A.G 1332 -)
t
Counterholder for clutch -MP 1-221-
1
/
turn (90°).
4
→
Chapter.
→
Chapter.
43