07.97.
Disconnect the plug from the air mass
–
meter -G70- and connect the multimeter
between contact 3 of the plug and the
engine mass.
–
Start engine and run in idle.
Specified value: 11...15 V
–
Switch off ignition.
If the voltage supply is o.k., check signal
–
lines and earth connection
If no voltage is present:
Check the cable connection from contact
3 of the plug to fuse no. 43 for continuity
–
and/or short-circuit to earth, if necessary
repair cable connection
diagrams and Fitting
If fuse and wiring are o.k. but neverthless
–
no voltage is present, check the fuel
pump relay
→
Chapter.
Check the signal line and the earth
connection of the air mass meter on
vehicles ► 07.97.
Connect the test box -V.A.G 1598/22- to
–
the wiring loom of the engine control unit
→
Chapter.
Test wiring from plug of air mass meter to
–
engine control unit for interruption or
short-circuit to positive or earth.
Plug of air mass meter G70
–
If the wiring is O.K., replace air mass meter -G70-.
Check the voltage supply of the air mass meter on vehicles 08.97 ►
Disconnect the plug -1- from the air mass
–
meter -2- and connect the hand-held
multimeter between contact 3 of the plug
and the engine mass.
–
Start engine and run in idle.
→
Anchor.
→ Current flow
locations.
1
2
Test box - V.A.G 1598/22-
209
13
12