Skoda OCTAVIA MK1 Service Manual page 121

– coat with hot bolt paste -G 052 112 A3-
9 - Washer
10 - Lambda probe, 50 Nm
coat only thread with hot bolt paste
–
-G 052 112 A3-; hot bolt paste must not
get into the slot of the probe body
test: → 1.6 ltr./74 kW Motor, Simos 2
–
Injection and ignition system; Rep. Gr. 24
Plug connection for lambda probe is
– located below the protective cover
→ Anchor
11 - Clamping sleeve
Align exhaust system free of stress
–
before tightening
Fitting position: synchronous running to
– vehicle floor, bolted connection pointing
to left
– Tighten bolted connections evenly
12 -
13 - Hanger
14 - Front and rear silencer
Replace individually when carrying out
–
repairs → Chapter
Align exhaust system free of stress
–
→ Chapter
Installed position of the hanger
The angled side -arrow- at the base of the
hanger points in direction of travel.
→ Chapter
40 Nm
121