Unscrew oil pressure switch and screw in
–
oil pressure tester (e.g. - V.A.G 1342-).
Screw oil pressure switch -2- into the test
–
equipment -V.A.G 1342-.
Connect brown cable -1- of tester to
–
earth (-).
Connect voltage tester to oil pressure
–
switch -2- and to battery positive (+).
The LED must not light up.
The oil pressure switch must be replaced
–
if the LED lights up.
Start engine and slowly increase engine
–
speed.
The LED must come on at an
–
overpressure of 0.12 to 0.16 MPa (1.2 to
1.6 bar). The oil pressure switch must be
replaced if it does not come on.
Testing oil pressure
Unscrew oil pressure switch and screw in
–
the tester - V.A.G 1342-.
Screw oil pressure switch into the tester
–
-V.A.G 1342 -.
Start engine (engine oil temperature at
–
least 80°C).
Oil pressure when engine idling: min. 0,2
t
MPa (2 bar)
Oil pressure at 2000 rpm: 0.30 to 0.45
t
MPa (3 to 4.5 bar)
If the specified values are not reached:
Eliminate any mechanical damage, e. g.
–
bearing damage.
Replace pressure relief valve in the oil
–
filter holder
→
Chapter.
At a higher engine speed the oil pressure
must not be greater than 0.7 MPa (7 bar).
If the specified pressure is exceeded:
–
Inspect oil galleries.
– Replace if necessary pressure relief valve
92