Holding pressure after 10 minutes
Injection valves
1)
If the engine is warm the resistance of the injection valves increases by approx. 4...6 Ω.
Overview of fitting locations
For vehicles ► 07.97
The components A and B are not shown on the overview figure.
A -
Lambda probe -G39- with heating for lambda probe -Z19-
q
immediately upstream of the catalytic converter
disconnected
at least 0.15 MPa (1.5 bar) overpressure
Injection jet
Resistance
(ambient temperature)
→ Note
184
bar)
equal for all valves
approx. 14.5 Ω