Currents/Voltages" View; Figure 91: Measured Values - Currents And Voltages - WAGO 750-495/040-00 Series Manual

WAGO-I/O-SYSTEM 750 XTR
750-495/040-00x 3-Phase Power Measurement Module 690 V
However the peak values are only displayed if this phase was selected for peak
value measurement. See section "Configuration with WAGO-I/O-CHECK" >
"'I/O Module' Tab."
8.5.6.2

"Currents/Voltages" View

The "Currents/Voltages" view shows all currents, voltages, phase angles and
frequencies of the 3 phases together, including minimum, maximum, average
and peak values:
• Current
• Phase voltage
• Line-to-line voltage, L1-L3
• Phase angle
• Frequency
• Neutral conductor current and Tamper Detect (fault current detection)
Figure 91: Measured Values – Currents and Voltages
However the peak values are only displayed for the phase that was selected for
peak value measurement. See section "Configuration with WAGO-I/O-CHECK" >
"'I/O Module' Tab."
Overcurrent, undervoltage and overvoltage, as well as Tamper Detect, are
marked with a red square if present and with a green square if not.
Commissioning 239
Manual
Version 1.2.0