WAGO 750-495/040-00 Series Manual page 183

WAGO-I/O-SYSTEM 750 XTR
750-495/040-00x 3-Phase Power Measurement Module 690 V
The main menu (1) offers the following tabs:
- I/O Module
- Phase L1
- Phase L2
- Phase L3
- Energy
- Factory defaults (depending on the selected network topology)
- Application (eliminated in software versions 1.8.5.556 and above)
You can find more information on this in section "Settings and Measured
Values ..." for the respective measurement topology.
The command bar (2) offers four buttons with the following options:
Button
[Import]
[Export]
[Save]
[Close]
Function
Opens a dialog to load settings that you saved previously,
e.g. when configuring another I/O module, from your hard
drive.
You can edit these settings further and finish by saving
them in the I/O module with [Save].
Note: Energy values are disregarded during import and
export.
Opens a dialog to save the current settings on your
computer for further parameterizations.
Note: Energy values are disregarded during import and
export.
Writes all modified settings to registers, i.e. the
configuration of the I/O module and the application
settings are modified.
The "Settings" dialog closes.
Closes the "Settings" dialog and discards all modified
settings that you have not saved.
Commissioning 183
Manual
Version 1.2.0