Table 123: Parameter 45 (Supported By Firmware Versions 05 And Above); Table 124: Parameter 46 (Supported By Firmware Versions 05 And Above); Table 125: Parameter 47 (Supported By Firmware Versions 05 And Above) - WAGO 750-495/040-00 Series Manual

302 Appendix

Table 123: Parameter 45 (Supported by Firmware Versions 05 and above)

Parameter 45 – Mutual Inductance M
Mutual Inductance M for Rogowski Coils
0 ... 15: 0...65535: Mutual inductance with a resolution of 0.01 nH / LSB
6400:

Table 124: Parameter 46 (Supported by Firmware Versions 05 and above)

Primary Voltage, Voltage Transformer VT
0 ... 15: 0:
1...65535: Primary voltage of the voltage transformer * VT scaling
2770:
The scaling of the primary voltage is set in parameter 43, bit 4 and is either0.1 V
per LSB or 1 V per LSB.

Table 125: Parameter 47 (Supported by Firmware Versions 05 and above)

Parameter 47 – Secondary Voltage, Voltage Transformer VT
Secondary Voltage, Voltage Transformer VT
0 ... 15: 0:
1...65535: Primary voltage of the voltage transformer × VT scaling
2770:
The scaling of the secondary voltage is set in parameter 43, bit 4 and is
either0.1 V per LSB or 1 V per LSB.
The SAG level depends on the nominal input voltage level.
For secondary voltage setting
- ≤ 120 V
- > 120 V
With a secondary voltage setting of
- ≤ 120 V
- > 120 V
Manual
Version 1.2.0
750-495/040-00x 3-Phase Power Measurement Module 690 V
Function
64.00 nH (factory setting)
Parameter 46 – Primary Voltage, Voltage Transformer VT
Function
invalid
(factory setting)
Function
invalid
(factory setting)
, the SAG level is U
RMS
the SAG level is U
RMS
, the nominal input voltage is U
RMS
, the nominal input voltage is U
RMS
WAGO-I/O-SYSTEM 750 XTR
for Rogowski Coils
RC
Data Type
UINT
Data Type
UINT
Data Type
UINT
= 30 V
LN RMS
= 60 V
LN RMS
200 V
LN =
400 V
LN =
Access Factory Setting
RW 0x1900 (dec.6400)
Access Factory Setting
RW 0x0AD2 (dec.2770)
Access Factory Setting
RW 0x0AD2 (dec.2770)
RMS
RMS