Status Bar - WAGO 750-495/040-00 Series Manual

WAGO-I/O-SYSTEM 750 XTR
750-495/040-00x 3-Phase Power Measurement Module 690 V
8.1.4

Status Bar

The status bar shows the following information:
- Connection status of the I/O module
- IP address of the fieldbus coupler/controller or name of the COM port
- nickname of the configured measurement topology (with firmware versions 05
and above)
In addition, error messages are shown for each phase. These depend on the
configured measurement topology; see section "Diagnostics".
The following error messages are possible.
NoZeroPoint
VoltClip (voltage signal not in measurable range – limited)
CurClip (current signal not in measurable range – limited)
VoltSag (high measurement error – min. measurement voltage underrun)
Commissioning 181
Manual
Version 1.2.0